Table of Contents
Advertisement
∫ Counter Reset Function
Before starting to record or play back to reset the
Elapsed Tape Time Indication to [0:00.00].
1
Set [C.RESET] on the [DISPLAY SETUP]
Sub-Menu of the [VCR FUNCTIONS] or the
[CAMERA FUNCTIONS] Main-Menu to
[YES].
≥When recording or playback starts, the
elapsed tape time is indicated in hours,
minutes and seconds. During playback of
parts of the tape on which no recording has
been made, this indication does not change.
≥If you rewind the tape further than the tape
counter position [0:00.00], the minus sign [–]
appears in front of the Tape Counter
Indication.
≥The Tape Counter Indication is automatically
reset to [0:00.00] when you take out the
cassette, remove the Battery or use the
High-Speed Rewinding Function.
∫ Memory Stop Function
The Memory Stop Function is convenient for the
following operations.
Rewinding or fast-forwarding the tape to a
desired position
1
Reset the Tape Counter to zero at the tape
position from which you want to play back
later.
2
Set [DISPLAY] on the [DISPLAY SETUP]
Sub-Menu of the [VCR FUNCTIONS] or the
[CAMERA FUNCTIONS] Main-Menu to
[MEMORY].
3
Start playback or recording.
4
After playback or recording is finished:
Set the [CAMERA/OFF/VCR] Switch to
[VCR].
5
Press the [5] or [6] Button.
The tape automatically stops approximately at
the position at which you reset the counter to
zero.
≥During High-Speed Rewinding, the Tape Counter
shows [0:00.00]. However, this does not activate
the Memory Stop Function.
∫ Demonstration Mode
When the Movie Camera is turned on and in the
Camera Mode without any cassette inserted, and
you leave it for 10 minutes without activating any
function, it automatically switches over to the
Demonstration Mode which demonstrates its many
functions.
≥You can also start the Demonstration Mode by
setting [DEMO MODE] on the [OTHER
FUNCTIONS] Sub-Menu of the [CAMERA
FUNCTIONS] Main-Menu to [ON] and then
exiting the menu.
≥Pressing a button or displaying a menu
temporarily suspends the Demonstration Mode.
However, if you leave the Movie Camera in this
condition without activating any function for more
than approximately 10 minutes, the
Demonstration Mode resumes.
≥If you do not want the Demonstration Mode to be
activated, set [DEMO MODE] on the [OTHER
FUNCTIONS] Sub-Menu to [OFF].
≥If you set the [CAMERA/OFF/VCR] Switch to
[CAMERA] while pressing the [1] Button,
[DEMO MODE] is automatically set to [ON] and
the Demonstration Mode starts immediately.
≥If you set the [CAMERA/OFF/VCR] Switch to
[CAMERA] while pressing the [∫] Button,
[DEMO MODE] is automatically set to [OFF].
69
Advertisement
Table of Contents
