Table of Contents
Advertisement
3
Adjust by turning the Eyepiece Corrector
Lever.
3
Adjust the angle of the LCD Monitor according
to the desired recording angle.
The LCD Monitor rotates upward a maximum of
180° and downward a maximum of 90° from its
normal vertical position. Trying to forcefully rotate
it beyond this range could seriously damage the
Movie Camera.
180˚
12:30:45
12:30:45
12:30:45
15.10.2001
15.10.2001
15.10.2001
12:30:45
15.10.2001
90˚
Attaching the Lens
Cap
Attach the shorter loop
of the Lens Cap Cord to
the Grip Belt.
You can attach the
removed Lens Cap onto
the Grip Belt.
You can attach the Lens
Cap to the Lens Cap
Holder on the Grip Belt.
≥Before you start recording, remove the Lens Cap.
≥When not actually recording, always attach the
Lens Cap to the Lens to protect it.
Remarks, etc.
≥Do not hold the Movie Camera by
the Viewfinder or apply any
pressure on it.
≥If sunlight or other strong light
enters the Viewfinder, sparkling
noise will occur on the Viewfinder
screen. If you block off the light, this
phenomenon disappears after a few
minutes and does not affect the
recorded picture.
≥If a subject with strong contrast or a
menu is displayed in the Viewfinder,
a ghost image may remain
temporarily. However, this is not a
malfunction and does not affect the
recorded picture.
≥The picture seen on the LCD Monitor looks slightly
Stretched vertically, however, the actually recorded
picture remains unaffected by this.
Closing the LCD Monitor
Push the LCD Monitor close until the [3OPEN] Lever
locks with a click.
21
Advertisement
Table of Contents
