Calling.with.headset; Preparation For Calling (Bluetooth Connection) - Sony Walkman WLA-NWB1K Operating Instructions Manual

Calling with headset

Preparation for calling (Bluetooth connection)

Check the following before operating the headset.
– The Bluetooth function is active on the mobile phone.
– Pairing of the headset and the Bluetooth mobile phone is complete.
1
Press and hold the POWER button for about 3 seconds while the
headset is turned off.
The headset indicator (blue) and headset indicator (red) flash
together twice, the headset turns on and then the headset tries to
connect to the last Bluetooth mobile phone that was used.
Note
Do not press and hold the POWER button for more than 7 seconds, otherwise
pairing mode is entered.
 Tip
The headset will stop trying to connect to the Bluetooth mobile phone after 1
minute. In such a case, press the multi function button to try to connect again.
To adjust the volume
Press the VOL � or – button.
 Tips
 You cannot adjust the volume when not communicating.
 Volume level for calling and listening to music can be set independently.
Headset indicator (red)
VOL – button
VOL + button
Multi function button
POWER button
Headset indicator (blue)
2