Central Pneumatic 95029 Assembly And Operating Instructions Manual

1/4” composite air die grinder

Advertisement

1/4" COMPOSITE AIR DIE GRINDER
95029
ASSEMBLY AND OPERATING
INSTRUCTIONS
Due to continuing improvements, actual product may differ slightly from the product described herein.
®
3491 Mission Oaks Blvd., Camarillo, CA 93011
Visit our Web site at http://www.harborfreight.com
TO PREVENT SERIOUS INJURY,
READ AND UNDERSTAND ALL WARNINGS
AND INSTRUCTIONS BEFORE USE.
Copyright
2006 by Harbor Freight Tools
. All rights reserved. No portion of this manual or any
©
®
artwork contained herein may be reproduced in any shape or form without the express written
consent of Harbor Freight Tools.
For technical questions and replacement parts, please call 1-800-444-3353.
Manual Revised 11h

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 95029 and is the answer not in the manual?

Questions and answers

Subscribe to Our Youtube Channel

Summary of Contents for Central Pneumatic 95029

  • Page 1 TO PREVENT SERIOUS INJURY, READ AND UNDERSTAND ALL WARNINGS AND INSTRUCTIONS BEFORE USE. Copyright 2006 by Harbor Freight Tools . All rights reserved. No portion of this manual or any © ® artwork contained herein may be reproduced in any shape or form without the express written consent of Harbor Freight Tools.
  • Page 2: Specifications

    Wear restrictive hair covering to contain long hair. Stay alert. Watch what you are doing and use common sense when operating a pneumatic tool. Do not use a pneumatic tool while tired or under the influence SKU 95029 For technical questions, please call 1-800-444-3353 Specifications 1/4”...
  • Page 3 (not included) into the Air Inlet (13) fitting of the Die Grinder. 19. Always disconnect the Die Grinder from its compressed air supply source, and squeeze the Trigger Lever (14) to release all compressed air in the tool before performing any maintenance or services.
  • Page 4 When unpacking, check to make sure the parts listed on page 7 are included. If any parts are missing or broken, please call Harbor Freight Tools at the number on the cover of this manual as soon as possible.
  • Page 5 Trip the Lever Pin (15) with your finger. Then slowly apply hand pressure to the Lever (14) until the desired speed is obtained. (See Figure C.) NOTE: The Die Grinder always turns the Grinding Drum clockwise (reference: while holding the tool as you would when operating it).
  • Page 6 Never use dam- aged equipment. Daily: With a clean cloth, remove all dirt, oil, and grease from the Die Grinder. If neces- sary, you may use a mild detergent. Do not use solvents, as damage to the Die Grinder may occur.
  • Page 7: Parts List And Diagram

    Air Inlet Trigger Lever Lever Pin NOTE: Some parts are listed and shown for illustration purposes only and are not available individually as replacement parts. SKU 95029 For technical questions, please call 1-800-444-3353 Parts List and Diagram Q’ty Part Bearing...
  • Page 8 90 Day Warranty Harbor Freight Tools Co. makes every effort to assure that its products meet high quality and durability standards, and warrants to the original purchaser that this product is free from defects in materials and workmanship for the period of 90 days from the date of purchase.

Table of Contents

Save PDF