Phase Adjustments - Sony UVW-1800 Operating Instructions Manual

Phase Adjustments

5-12 (E) Chapter 5 Editing
4 Adjust the phase synchronization control on the Vectorscope so that the sync
and subcarrier phases are close to the reference line.
5 Output the player 1 signal from the PVE-500.
6 Press the A channel button on the Vectorscope.
This displays the sync phase and subcarrier phase (composite signals only) of
the signal from player 1.
I On the subsidiary control panel of player 1, adjust the SYNC and SC
adjustment controls, using a Phillips screwdriver, so that the output from player
1 on channel (A) is in correct phase alignment with the black burst signal on
channel (B).
When component signals are used the subcarrier phase does not appear.
8 Output the player 2 signal from the PVE-500.
Repeat steps 6 and 7 to adjust the sync and subcarrier phase of the output from
player 2.