Warning Messages - Sony UP-2300 Operating Instructions Manual

Message
On the monitor
INSERT RIBBON AND PAPER
REMOVE PRINTS
REMOVE PAPER: TRAY

Warning messages

Warning message
In the printer window display
On the monitor
PLEASE WAIT
PLEASE WAIT
NOW PRINTING NOW PRINTING
HIT ANY KEY
HIT ANY KEY
INPUT MISMATCH
INPUT MISMATCH
INPUT ILLEGAL
PLEASE WAIT PLEASE WAIT
RESERVED MEMORY RESERVED MEMORY
PLEASE WAIT PLEASE WAIT
PRINTING MEMORY PRINTING MEMORY
NO INPUT
NO INPUT
NO IMAGE NO IMAGE
PLEASE WAIT PLEASE WAIT
HEAD IN COOLING
HEAD IN COOLING
PLEASE WAIT
PLEASE WAIT
SET IN COOLING SET IN COOLING
In the printer window display
INSERT RIBBON
SET PAPER
REMOVE PRINTS
REMOVE PAPER TRAY
In the case of a warning, only warning messages appear. The ALARM lamp does
not light.
Possible causes and remedies
The printer is printing, preventing any other operation.
n Wait until the printer finishes printing, then retry the operation.
This message appears when the remote control unit is used in CAPTURE
STOP mode and when the printer stops capturing images to memory pages
once images have been captured to all memory pages.
n Press any button. Printer operation is enabled after this.
• The TV system of the signal input from the source equipment (VTR, video
camera and so on) is not compatible with the TV system of your printer.
n Check the signal of TV system and input the correct one.
• The signal other than the video signal (such as audio signal and similar) is
input.
n Input the correct video signal.
Printing is queued for the selected memory page.
n Retry the operation once the printer finishes printing.
The image captured in the selected memory page is being printed.
n Retry the operation once the printer finishes printing.
The printer is not receiving an input signal from equipment corresponding to
the input selected on the INPUT SETUP menu.
n Check the input signal selected on the INPUT SETUP menu. (page 14)
n Check whether the video equipment is outputting a video signal in
playback mode.
n Check that the connections between signal source equipment and the
printer are secure. (page 65)
The image is not captured in memory.
n Capture the image in memory then start printing. (page 16)
The thermal head has overheated.
n Leave the printer until the head cools down and this message
disappears. The printer starts printing automatically.
The inside of the printer has overheated.
n Leave the printer until its inside cools down and this message
disappears. The printer starts printing automatically.
Possible cause and remedies
The ink ribbon cartridge and paper are not loaded.
n Load the ink ribbon cartridge and paper. (pages 9 and 12)
The maximum number of printouts has accumulated on the paper
cover.
n Remove the printouts from the paper cover.
The paper jams around the paper tray as it is being fed into the
ribbon area.
n Remove any jammed paper. (see page 104)
103
Others