Power Supply - Panasonic NV-MD9000EN Operating Instructions Manual

ª
Using the Remote Controller
1
Direct the Remote Controller to the
Remote Control Sensor
Camera and press an appropriate button.
(3)
15˚
15˚
15˚
15˚
≥Distance from the Movie Camera: Within
approximately 5 metres
≥Angle: Within approximately 15o in the
vertical and horizontal directions from the
central axis
≥The above operative ranges are for indoor
use. Outdoors or under strong light, the Movie
Camera may not operate properly even within
the above ranges.
≥Within a 1-metre range, you can also use the
Remote Controller on the LCD Monitor side of
the Movie Camera.
Selecting Remote Controller Modes
When 2 Movie Cameras are used
simultaneously, they can be operated
individually by selecting different Remote
Controller Modes.
≥If the Remote Controller Mode of the Movie
Camera and that of the Remote Controller do
not match, [REMOTE] Indication is displayed.
Setup on the Movie Camera:
Set [REMOTE] on the [OTHER FUNCTIONS]
Sub-Menu to the desired Remote Controller
Mode. ( )
-45-
Setup on the Remote Controller:
6 1 5
STILL ADV PAUSE STILL ADV
2
E D
;
INDEX STOP INDEX
K L
∫
SELECT
[VCR1]:
Press the [D] Button and [∫] Button
simultaneously. 1
[VCR2]:
Press the [E] Button and [∫] Button
simultaneously. 2
≥When the battery in the Remote Controller is
replaced, the mode is automatically reset to
[VCR1] Mode.

Power Supply

ª
Using the AC Adaptor
DC IN 7.9V
(37)
1
Connect the AC Mains Lead to the AC
Adaptor and the AC mains socket.
Before Use
(3) of the Movie
T
W
1
1
-42-
≥The AC Mains Lead's outlet plug does not fit
entirely into the AC Adaptor socket. A gap
will remain as shown 1.
2
Connect the DC Input Lead to the [DC IN]
(37)
Socket on the Movie Camera.
3
Connect the DC Input Lead to the AC
Adaptor.
≥Before connecting or disconnecting the
power supply, set the [OFF/ON] Switch on
the Movie Camera to [OFF] and make sure
that [CAMERA/VCR] Lamps is not lit.
ª Using the Battery
Before use, fully charge the Battery.
1
Attach the Battery to the AC Adaptor and
charge it.
≥Since the Battery will not be charged when
the DC Input Lead is connected to the AC
Adaptor, disconnect it from the AC Adaptor.
≥The [POWER] Lamp and [CHARGE] Lamp
lights up, and charging starts.
≥When the [CHARGE] Lamp goes off,
charging is completed.
2
Attach the charged Battery to the Movie
Camera.
Disconnecting the Power Source
(50)
Set the [OFF/ON] Switch
disconnect the DC Input Lead or while pressing
the [PUSH] Button (35) , slide the Battery
upward to disconnect it.
PUSH
(35)
ª
Using the Car Battery Charger
If you use the Car Battery Charger (VW-KBD2E;
optional), you can supply power to the Movie
Camera and charge the battery inside your car.
For further information, refer to the instruction
manual of the Car Battery Charger.
Be sure to start the car engine before you
connect the Car Battery Charger, otherwise the
fuse may blow.
≥For other notes concerning this item, see
to [OFF] and,
OFF ON
(50)
.
-64-