Sharp UX-310 Operation Manual page 47

Direct Keypad Dialling
You can also enter a full number with the number keys and then press
the START key to begin dialling. You can use this method to dial a
full number when you don't need to speak to the other party before
faxing.
Note: Direct Keypad Dialling cannot be used to dial a number within the
same PBX as your fax machine. To send a document to a fax
machine in your PBX, use Normal Dialling.
1
Load the document(s).
The display will show:
READY TO SEND
Set the resolution and/or contrast if
desired.
2
Enter the number of the receiving
machine by pressing the numeric keys.
If a pause is required between any
of the digits to access a special
service or an outside line, press the
REDIAL key. The pause will
appear as a hyphen. Several pauses
can be entered in a row.
3
Check the display. If the number of the
receiving machine shown is correct,
press the START key.
If it is not correct, press the STOP
key to backspace and clear one digit
at a time, and then re-enter the
correct digit(s).
Sending a Fax by Automatic Dialing
RESOLUTION
ABC
2
1
JKL
GHI
4
5
TUV
PQRS
7 8
START
DEF
3
MNO
6
WXYZ
9
45