Configuring Recording Settings; Record Mode Setup Screen; Figure 44 - Record Mode Setup Screen - Samsung SHR-3091 User Manual

Digital Video Recorder

Configuring Recording Settings

Your DVR offers a variety of flexible recording modes. You can set it up to record all the time
or to only record events. It can be set up to continue recording once the hard disk drive is full by
recording over the oldest video, or you can set it up to alert you when the hard disk is full and
stop recording.

Record Mode Setup Screen

Figure 44 — Record Mode Setup screen.
Highlight the Record Resolution box and select from High and Standard. All other variables
being equal; Selecting High will decrease the recording and playback speed by half than
Standard.
Highlight the box beside End Of Disk and press the button. This toggles between
Overwrite and Stop. When in the Overwrite mode, the DVR continues recording when the
hard disk drive is full by overwriting the oldest video. When in the Stop mode, the DVR stops
recording when the hard disk drive is full.
If the DVR is set to the Stop mode, you can set it to beep or activate the Alarm Out AO1 port
when the hard disk drive is full. Highlight the box beside On Disk Full: Beep and press the
button to toggle between On and Off. Highlight the box beside On Disk Full: Alarm Out and
button to toggle between On and Off.
press the
Highlight the box beside Field Detect. Pressing the
button toggles between On and Off.
When set to On, the Field Detection helps prevent shaking. It does this by recording odd
numbered fields from odd numbered cameras and even numbered fields from even numbered
cameras.
37