Assigning The Com Ports To The Devices; Operating Gigaset Talk&Surf With A Wireless Data Device - Gigaset 3070 isdn User Manual

Gigaset 3070/3075isdn, GB, A31008-G3070-B100-3-7619

Assigning the COM ports to the devices

Step
by
A PC is equipped with a number of different ports to enable it to communicate
Step
with other devices. The most common ports are the following:
The USB port
COM 1 - 2, on the hardware side
COM 3 - etc. virtual, i.e. only on the software side
The port layout is described briefly below:
Since there are three different ways in which the connected PC can access
Gigaset 3070/3075isdn (via Gigaset M101 Data, Gigaset M105 Data and the
USB cable), there are also three different configurations. Data from the Internet
(AOL, T-Online, RDT, PPP , X.75) or from another PC is preprocessed by the PC
itself over the relevant drivers and a virtual COM port (3 and higher) and sent
to the TAPI Service Provider (TAPI = Telephony Application Interface). The TAPI
interface then accesses the port that has been appropriately configured. With
a connection via USB cable, this is the USB port itself; with Gigaset M101 Data,
this is COM port 1 or 2 and with Gigaset 105 Data this is a virtual COM port,
which is routed via the USB port.
Overview:
AOL
T-Online
RDT
PPP
X.75
Since a virtual COM port is upstream of the Gigaset M105 Data, the port must
be configured as a serial port in this case and not as a USB.
Operating Gigaset talk&surf with a wireless data device
If it is not possible to use the USB port of Gigaset 3070/3075isdn (lengthy or
complex cabling etc.), wireless PC operation at Gigaset 3070/3075isdn devices
is also possible.
For this purpose, you will need either
Gigaset M101 Data with connection via COM port, or
Gigaset M105 Data with connection via USB and virtual COM port.
Connecting a PC to the base station
Virtual
TAPI
COM port
giga3070KAP .fm 09.01.01
COM1 at M101
USB at G3075
Virtual
USB at M105
COM port
13