Siemens WDI1442 Instruction Manual And Installation Instructions page 43

Electrical
connection
Caution:
The washer dryer must be connected correctly to an
A.C. contactor socket.
The mains voltage must comply with the voltage infor
mation given on the identification plate.
The connected load and the necessary fusing are
shown on the identification plate.
Ensure that:
- the plug and the socket are compatible.
- the wire cross section is sufficient.
- the earth system is installed in accordance with
regulations.
If the mains cable needs altering, this should only be
done by the after sales service.
Do not use multiple plugs/connectors and/or exten
sion cables.
Only use current operated circuit breakers which are
marked as follows: 7.
Do not touch the plug with wet hands.
Always pull the plug grip to remove the plug from the
socket.
43