Table of Contents
Advertisement
Fault displays
Text on display panel
"Tap closed?"
"Tap closed?" even
though a lot of water
has run in.
"Pump blocked?"
p
Door open?"
Aqua Stop actuated?
If the fault cannot be rectified with the aid of the above tables:
q Switch off the appliance.
q Wait 5 seconds.
q Switch on the appliance.
q Select and start a programme.
i If the fault recurs, call Customer Ser
vice, see Page 51.
Possible cause
Tap not turned on.
Inlet hose kinked or pinched.
Filter blocked in water inlet hose.
Water pressure too low.
Safety function has detected an
appliance defect.
Pumped blocked by foreign objects.
Drainage pipe and/or drainage hose
blocked.
Door not closed properly.
Water in the base pan; appliance
leaking.
Remedial action
Turn the tap on. Programme will
continue automatically.
Eliminate cause.
Clean filter, see Page 44.
Eliminate cause.
Do not open the appliance door as
water may run out! Repeatedly select
"Drain" programme until the water
level is low enough to remove the
laundry. Call Customer Service.
Clean pump, see Page 43.
Clean drainage pipe and/or drainage
hose.
Check whether an item of laundry is
jammed; close the door.
Call Customer Service.
49
Hide quick links:
Advertisement
Table of Contents
