Table of Contents
Advertisement
Connecting the power
Warning
Connect the washing machine only to an
alternating current via a correctly installed
earthed socket.
The mains voltage and the voltage speci
fications on the washing machine (rating
plate) must correspond.
Connected load and the required fuse are
indicated on the rating plate.
Ensure that:
- The mains plug and socket are com
patible.
- The cable cross section is adequate.
- The earthing system has been installed
correctly.
The mains cable may be changed (if re
quired) by an electrician only.
A replacement mains cable can be obtai
ned from customer service.
Do not use multiple plugs/sockets or ex
tension cables.
If a residual current operated circuit brea
ker is used, ensure that it bears the follo
wing symbol: 7.
Only this symbol guarantees compliance
with currently valid regulations.
Do not insert/pull out the mains plug with
wet hands.
Do not pull out the mains plug by tugging
the cable.
Transporting the washing
machine
Before you transport the washing machi
ne (e.g. when moving house)
- Turn off the tap.
- Reduce the water pressure in the wa
ter inlet hose (see Page 44).
58
- Drain off any residual water (see Pa
ge 43).
- Disconnect the washing machine from
the power supply.
- Remove the hoses.
- Remove the two lower covers.
Preparing transportation protection
devices
q Pull the bolt out of the bush until the
end of the bolt is flush with the end of
the bush.
Installing transportation protection
devices
q Through the open washing machine
door have a second person pull the
top of the drum forwards and hold in
this position.
Insert the transportation protection de
vices 1 and 2 and tighten the bolts.
The washer lugs must be located in
the groove in the rear panel of the hou
sing.
After transporting and correctly installing
and connecting the washing machine and
removing the transportation protection
devices, run the Drain" additional pro
gramme before starting the first wash pro
gramme.
Hide quick links:
Advertisement
Table of Contents
