Gigaset A100 Operating Manual page 8

Putting the telephone into service
Step 3: Registering the handset at the base station
Before you can make or receieve telephone calls you need
to register the handset at the base station.
Make sure that the base station is connected to
the power supply (Step 1) and the battery is
inserted in the handset (Step 2).
k
Ö
Place the handset in the base station and
leave it there until registration is complete.
The registration display will appear. This may
take up to 5 minutes, depending on the
charge level of the battery.
/
The symbol will flash in the display.
Unplug the power supply unit (220V/230V)
from the mains socket.
The handset must remain in the base sta-
tion. Plug the power supply unit back into
the mains socket.
After about 90 seconds the
stop flashing and the normal standby display
will appear. The handset is now registered at
this base station.
6
/
symbol will