Configuration Parameters In Cfg Files - Yealink T19P User Manual

If you want to reset the configuration of a parameter, set the value of the parameter to !NULL!
or %NULL%. For example, local_time.ntp_server1 = %NULL%. After the auto provisioning
process is completed, the NTP server 1 will be reset to "cn.pool.ntp.org".
Permitted
Parameter
Values
network.ip_ad
0, 1 or 2
dress_mode =
network.intern
0, 1 or 2
et_port.type =
network.static
0 or 1
_dns_enable
=
network.intern
IPv4 address
et_port.ip =
Descriptions
It configures the IP address mode.
0-IPv4
1-IPv6
2-IPv4&IPv6
The default value is 0.
It takes effect after a reboot.
It configures the Internet (WAN) port
type for IPv4 when the IP address
mode is configured as IPv4 or
IPv4&IPv6.
0-DHCP
1-PPPoE (not applicable to
SIP-T42G/T41P IP phones)
2-Static IP Address
The default value is 0.
It takes effect after a reboot.
It enables or disables the phone to use
manually configured static IPv4 DNS
when Internet (WAN) port type for IPv4
is configured as DHCP .
0-Disabled (use the IPv4 DNS obtained
by DHCP)
1-Enabled
The default value is 0.
It takes effect after a reboot.
It configures the IPv4 address when the
IP address mode is configured as IPv4
or IPv4&IPv6, and the Internet (WAN)
port type for IPv4 is configured as
Static IP Address.
The default value is blank.
Appendix
Web Setting Path
Network->Basic->
Internet Port->
Mode (IPv4/IPv6)
Network->Basic->
IPv4 Config
Network->Basic->
IPv4 Config->Static
DNS
Network->Basic->
IPv4 Config->Static
IP Address->IP
Address
65