Manual Tuning - Panasonic CQ-VA7300N Operating Instructions Manual

Radio
E
N
G
L
I
Mode Display Band/frequency FM Stereo Indicator
S
H
ASPECT TILT
11
ASPECT
ASP CQ-VA7300N TILT OPEN / CLOSE
CQ-VA7300N
EON PTY CT IN-DASH 7 INCH COLOR LCD MONITOR WITH RECEIVER
TRACK
TUNE
VOL VOL VOL
MUTE MUTE MUTE
[]][[]
POWER
NAVIGATION PTY MONO/ST
LOUD
ENTER ENTER
NAVI DISP TA AF AF MODE MODE MENU
[AF] [MODE] [ENTER]
PTY Display
(Band)
[] ] [[ ] (Tune)
[{] [}] (Preset)
[MODE]
[1] - [6] (Preset)
[AF]
[LOC] (Local)
[]][[] (Tune)
[ENTER] (Band)
Mono/Local Selection (MONO/LOC)
MONO: Noise is significantly decreased when weak signals are received from an FM broadcast station.
LOCAL: Only strong signals of stations are searched for in seek tuning, while at the LOCAL OFF setting, relatively weak
signals are also searched for.
Local Mode
[Default: LOCAL OFF]
Press [LOC] (Local) to switch the LOCAL mode on
and off. (Only for remote control)
LOCAL OFF
LOCAL ON
12
CQ-VA7300N
Sub-LCD Display (at monitor close)
Band Preset number Frequency
"Sub-LCD Display Change" (a page 38)
q
Radio Mode
Press [MODE] to change to the AM/FM
(LW/MW) mode.
w
Band
PRESET / DISC
Press [ENTER] to change the band.
FM1
Note: The stereo indi-
FM2
cator lights during
reception of an FM
FM3
stereo broadcast.
AM
e

Manual Tuning

[[]: Higher frequency
[]]: Lower frequency
Seek Tuning
Press and hold for more than 0.5 seconds then
release.
[[]: Higher frequency
[]]: Lower frequency
Tuning will automatically stop when the signals
of the next broadcast station are received.
Monaural Mode
[Default: MONO OFF]
Press and hold [AF] to switch the MONO mode on
and off.
MONO OFF
MONO ON
Station Preset
Perform these operations with the remote control.
Up to 6 stations each can be saved in the FM1, FM2, FM3 and AM preset station memories.
Select a band and frequency. (step w and e on the previous page)
Press and hold [1] to [6] for more than 2 seconds.
Manual Preset
Memory
Manually save a station in the
preset memory.
Select a band. (step w on the previous page)
Press and hold [ENTER] for more than 2 seconds.
Auto Preset
Memory
Automatically save stations with
good reception in the preset ¡The 6 stations with good reception will be automatically saved in the
memory under preset numbers 1 to 6.
memory.
¡Once set, the preset stations are sequentially scanned for 5 seconds
each.
¡To stop the scanning, press [1] to [6].
Note: Only RDS stations will be saved at default setting (AF ON). To select
non RDS stations too, set AF OFF.
Note: New stations overwrite existing saved stations after following this procedure.
Select a band. (step w on the previous page)
Preset Station
Press [1] to [6].
Calling
Note: You can call up preset stations 1 to 6 by pressing [{] and [}]
on the display unit as well.
E
N
G
L
I
S
H
12
The frequency blinks once, and
a receiving station is saved in
the memory.
(a page 15)
13
CQ-VA7300N