Binding-Head Screw (5 Mm Ø X 6 Mm); Flat-Head Screw; (5 Mm Ø X 6 Mm); Binding-Head Screw (4 Mm Ø X 3 Mm) - Panasonic CQ-VA7300N Operating Instructions Manual

Installation
E
(continued)
N
G
L
I
❏ Installation Procedures (When not using Mounting Collar w)
S
H
Use the brackets supplied with your car when mounting this unit. The bracket shape and mounting method vary with car
45
manufacturers, car types and manufacturing year. Please consult your nearest dealer or installer.
Select mounting screws according to the hole positions and hole shape of the bracket.
t Binding-Head Screw (5
Recycle the Binding-Head Screws that fixed the transportation brackets for two more
positions.
u Binding-Head Screw (4
4 pieces
y Flat-Head Screw (5
mm ø x 6 mm)
Use the supplied Spacer i if mounting hole of your car is shaped like below.
Not used
Mounting Hole
of a Bracket
(in section)
Bracket
t Binding-Head Screw
(5 mm ø x 6 mm)
Existing Bracket (L)
o Double-Faced Adhesive Tape
(Bracket originally
attached to the car)
46
CQ-VA7300N
mm ø x 6 mm) 2 pieces
mm ø x 3 mm)
When using these
mounting holes
4 pieces
t Binding-Head Screw
i Spacer
o Double-Faced
Adhesive Tape
i Spacer
Cautions:
¡Never mount the unit in any of the following locations to avoid damage due to overheating;
1. Near the heater port.
2. Places like the dashboard or rear deck, where it may be exposed to direct sunlight.
¡Do not mount the unit near the door, where it could be exposed to rain.
❑ Mount the unit on the car carpet by using Velcro Tape !6 .
Attach the seal side of the Velcro Tape !6
to the hide-away unit, then mount the unit
on the carpet.
Note: Some carpet materials may not be
suitable for this mounting method. In this
case, please contact your nearest
Panasonic Service Center for installation.
(5 mm ø x 6 mm)
❑ Unit installation by using the Mounting Brackets !3 and the Base Brackets !4 .
Existing Bracket (R)
Let the bolts of the base bracket
pass the carpet.
Make cuts by using cutter.
Note: Apply an anticorrosive to the holes and tapping screws.
Caution: You run the risk of interfering with the mounting or causing damage by drilling into the gas tank, a wiring
harness, or other component.
Mounting the Hide-away Unit

!2 Hex. Nut (5

!3 Mounting Bracket

Carpet

!4 Base Bracket

Drill for 4.8 mm diameter holes to the chassis.
* Put the tape and the base bracket together with each hole of the tape and
bracket connected so that the screw goes in at two positions.
E
N
G
L
I
S
H
46

!6 Velcro Tape

ø)
mm
!0 Binding-Head Screw
(5 mm ø x 8 mm)

!1 Tapping Screw (6

ø x 20 mm)
mm
!5 Double-Faced Adhesive Tape
47
CQ-VA7300N