Controlling This Unit From A Dj Mixer; Mounting Rack - Pioneer CDJ-500II Operating Instructions Manual

APPLICATION OPERATION

Controlling This Unit from a DJ Mixer

By connecting the CONTROL jack of this unit with the
CONTROL jack of the optional DJM-500 or DJM-300
DJ mixer, the fader starting or back cuing of the player
can be controlled from the channel fader or cross-
fader of the mixer.
For the connection and operation, read the operating
instructions of the DJM-500 or DJM-300 DJ mixer.

MOUNTING RACK

÷ When using a commercially available 19-inch
standard rack (EIA) with a sliding shelf, use the
supplied screws and spacers for mounting the player
to the sliding shelf. The player's installation surface
board of the sliding shelf should be 1.6 mm ~ 2
mm thick.
1
Make 4 holes in the commercially available sliding
shelf.
2
Place the player with top panel down and remove
the screws of the foot. (Retain all screws.)
3
Put the sliding shelf on the player with the front
panel of the player and the front side of the sliding
shelf aligned.
4
Fix the sliding shelf to the player with the supplied
screws and spacers.
Caution for use of carrying case
When the CDJ-500II is used in a carrying case, be
careful for the following:
÷ During playback, use care so that the transportation
cushions do not contact the player, power cord or
audio cord; if vibration is transmitted through other
part than the feet of the product, sound skip may
occur.
Also be careful not to touch the
carrying case during playback.
D
14
<DRB1223>
En
1
30
290
2
Screw
|
Front side
260
4 - ø5
Unit : mm
3 4
Supplied screw
Foot
Supplied
spacer