Adjusting Loudness; Using Subwoofer Output; Adjusting Subwoofer Settings - Pioneer DEH-P8450MP Operation Manual

Section
Audio Adjustments
07
4 Press 5 or ∞ to adjust the treble level.
Each press of 5 or ∞ increases or decreases
the treble level.
+6
is increased or decreased.

Adjusting loudness

Loudness compensates for deficiencies in the
low- and high-sound ranges at low volume.
1 Press
OPEN
2 Press
AUDIO
Press until
AUDIO
3 Press 5 to turn loudness on.
Loudness level (e.g.,
display.
4 Press 2 or 3 to select the level.
Press 2 or 3 until the desired level appears in
the display.
(low)—
Low Mid
5 Press ∞ to turn loudness off.
appears in the display.
Loud OFF

Using subwoofer output

This unit is equipped with a subwoofer output
which can be switched on or off.
1 Press
OPEN
2 Press
AUDIO
When the subwoofer controller setting is
, you can select
Control:EXT
until
AUDIO Sub-W1
40 En
– is displayed as the level
–6
to open the front panel.
to select .
Loud
appears in the display.
Loud
) appears in the
Loud Mid
(mid)— (high)
High
to open the front panel.
to select .
Sub-W1
. Press
Sub-W1
appears in the display.
3 Press 5 to turn subwoofer output on.
Sub-W1 Normal
Subwoofer output is now on.
• You can turn off subwoofer output by pressing
∞.
4 Press 2 or 3 to select the phase of sub-
woofer output.
Press 2 to select reverse phase and
appears in the display. Press 3 to select normal
phase and

Adjusting subwoofer settings

When the subwoofer output is on, you can
adjust the cut-off frequency and the output level
of the subwoofer.
1 Press
OPEN
2 Press
AUDIO
When the subwoofer output is on, you can
select
Sub-W2
(Hz) appears in the display.
• If the subwoofer setting has been previously
adjusted, the frequency of that previously
selected will be displayed, such as
(Hz).
3 Press 2 or 3 to select cut-off frequency.
Press 2 or 3 until the desired cut-off frequency
appears in the display.
— —
50 80 125
• Only frequencies lower than those in the
selected range are output from the subwoofer.
4 Press 5 or ∞ to adjust the output level of
the subwoofer.
Each press of 5 or ∞ increases or decreases
S.W
the level of the subwoofer.
as the level is increased or decreased.
Press 5 or ∞ until you see the desired value
displayed.
appears in the display.
appears in the display.
Normal
to open the front panel.
to select .
Sub-W2
. Press until
AUDIO
(Hz)
–
+6 –6
Rev.
Sub-W2 80
(Hz) or
50 125
is displayed