Initial Settings
Switching the auxiliary setting
It is possible to use auxiliary equipment with
this unit. Activate the auxiliary setting when
using auxiliary equipment connected to this
unit.
1 Press
to open the front panel.
OPEN
2 Press
to select
FUNCTION
Press
until
FUNCTION
play.
on or off with 5/∞.
3 Select
AUX
Pressing 5/∞ will switch
off and that status will be displayed (e.g.,
).
AUX :ON
Switching the dimmer setting
To prevent the display from being too bright at
night, the display is automatically dimmed
when the car's headlights are turned on. You
can switch dimmer on or off.
1 Press
to open the front panel.
OPEN
2 Press
to select
FUNCTION
Press
until
FUNCTION
play.
on or off with 5/∞.
3 Select
DIM
Pressing 5/∞ will switch
and off and that status will be displayed (e.g.,
).
Dimmer :ON
.
AUX
appears in the dis-
AUX
between on and
AUX
.
DIM
appears in the dis-
DIM
between on
Dimmer
Selecting the brightness
You can select the display brightness. Initially
this mode is set to 12.
1 Press
to open the front panel.
OPEN
2 Press
to select
FUNCTION
Press
until
FUNCTION
display.
3 Select the desired brightness with 2/3.
• The display shows
–
0
Setting the rear output and sub-
woofer controller
This product's rear output (rear speaker leads
output and RCA rear output) can be used for
full-range speaker (
Rear SP:FULL
(
) connection. If you switch rear
Rear SP:S.W
output setting to the
Rear SP:S.W
nect a rear speaker lead directly to a subwoofer
without using an auxiliary amp.
Initially, the unit is set for rear full-range speaker
connection (
Rear SP:FULL
When rear output are connected to full range
speakers (when
Rear SP:FULL
can connect the RCA subwoofer output to a
subwoofer. In this case, you can select whether
to use the subwoofer controller's (low pass
filter, phase) built-in
S.W Control:INT
auxiliary
S.W Control:EXT
.
BRIGHT
appears in the
BRIGHT
.
15
) or subwoofer
, you can con-
).
is selected), you
or the
.
En
Section
08
45