Remote Control Of Other Component; Setting Up The Remote Control To Control Other Components - Pioneer VSX-908RDS-G Operating Instruction

Remote Control of Other Component

Before operating the receiver, be sure to press the main power button on the front panel to turn the
power ON (_).
Setting Up the Remote Control to Control Other
Components
In addition to controlling the receiver, the supplied remote control can operate your other components (VCR, TV,
LD, CD, etc.) after you program it to do so. In this way, instead of fumbling with many different controls and
buttons, you only need to use one remote control. If your component(s) are listed in the remote control's
memory, simply follow the steps below. If your component(s) are not listed, or if you want the remote control to
learn additional operations, you can use the learning mode to input the information from the remote controls
supplied with your other components.
Recalling preset codes
The following steps show you how to recall preset codes stored in the remote control. Once a preset code is
recalled and the component assigned, you can use this remote control to easily operate the component.
See "Preset Code List" on p. 78-81 for the components and manufacturers available.
Î
S0URCE RECEIVER
MULTI SYSTEM
OPERATION OFF
DVD/LD TV/SAT VCR1 VCR2
MULTI CONTROL
MD/
CD TUNER TV CONT
TAPE1
CLASS MPX BAND DIRECT ACCESS
¶ 7 3 8
- + - +
TUNING STATION
1 ¡ 4 ¢
- +
CHANNEL
3
2 3
1
4 5 6
8 9
7
+10 0 DISC
RF ATT DISPLAY
TV
TV VOL VOLUME
TV CONTROL
TV FUNC
EFFECT
MENU MUTE
/CH SEL
FUNCTION
ENTER
SIGNAL
SELECT
2/dts
SYSTEM
THX ADVANCED STANDARD
SETUP
2,3 MPEG
REMOTE
MIDNIGHT DSP STEREO
SETUP
DIGITAL NR
AV PREPROGRAMMED AND LEARNING
REMOTE CONTROL UNIT
54
1
Turn on your TV and the receiver.
1
Make sure your TV is set to the appropriate video input
(e.g. VIDEO 1).
2
Press the REMOTE SETUP button.
The Remote Setup menu appears on your TV screen.
You have four set up options:
1 Preset Recall
2 Learning
3 Multi Operation (See p.67), System OFF (See p.69)
4 Direct Function (See p.70)
Preset Recall and Learning are the two modes that teach the
remote control to operate your other components. It is easiest to
start with Preset Recall and, if setup is not possible, move on to
the Learning mode.
3
Press the REMOTE SETUP button and the
at the same time to select the Preset Recall setup
mode.
All the MULTI CONTROL buttons (except the TUNER button) start
to blink.
To cancel the Preset Recall setup mode
Press the REMOTE SETUP button.
Select Remote
Setup Mode
Remote SETUP+1
Preset Recall
Remote SETUP+2
Learning
Remote SETUP+3
Multi-Operation
Remote SETUP+4
Direct Function
button
1