Oil Top Up - PIAGGIO MSS X9 EVOLUTION 250 Workshop Manual

Maintenance
Replacement
- Loosen the oil loading cap/bar.
- Loosen the network filter unloading cap «A» on
the flywheel side and let the oil drain out com-
pletely.
- Extract the oil cartridge «B» filter using the two
protruding tabs and remove it.
- Install a new oil filter lubricating the filter sealing
O-Ring with engine oil.
- Tighten the drainage cap again and fill with ~ 600
- 650 cc oil.
- Start the engine, let it run for a few minutes and
then stop it.
- Wait a few minutes, then remove the cap - bar
and check the level. Fill in with the prescribed oil
up to reach the MAX level.
Check
This operation must be carried out with the engine cold and following the procedure below:
1. Place the vehicle on its centre stand and on flat ground.
2. Undo cap/dipstick "A", dry it off with a clean cloth and replace it, screwing down completely.
3. Remove the cap/dipstick again and check that the level is between the min and max. marks; top
up if necessary.
The MAX level mark indicates a quantity of around 1300 cc of engine oil. If the check is carried out after
the vehicle has been used, and therefore with a hot engine, the level line will be lower; in order to carry
out a correct check, wait at least 10 minutes after the engine has been stopped so as to get the correct
level.

Oil top up

The oil should be topped up after having checked
the level and in any case by adding oil without
ever exceeding the MAX. level.
Restoration of the level from MIN to MAX requires
approximately 200 cc.
MAIN - 40
MSS X9 Evolution 250