PIAGGIO MSS X9 EVOLUTION 250 Workshop Manual page 150

Engine
Walbro
To detach the carburettor from the engine, it is
necessary to move the air filter and remove the
transmission throttle control, the automatic starter
connexion, the clamps anchoring the carburettor
to the filter housing and to the inlet manifold, the
air delivery pipe to the diaphragm, and the intake
fitting.
- Take out the carburettor and rotate it so as to
remove the screw with the water joint and the
pipes
N.B.
THIS OPERATION IS NECESSARY TO AVOID LOSING
SPRAYER PARTS WHEN CLEANING THE CARBURETTOR
BODY. IF THE SPRAYER IS FORCED IN ITS HOUSING DO
NOT ATTEMPT TO REMOVE IT AS THIS WILL ONLY DAM-
AGE IT.
Remove the protection, the bracket and the starter
acting on the screw shown in the figure.
Remove the clamp and cover with the airing filter
of the diaphragm chamber.
ENG - 150
MSS X9 Evolution 250