Panasonic KX-TG8100FX Operating Instructions Manual page 46

TG8100-8120FX(e).book Page 46 Wednesday, August 9, 2006 3:13 PM
Useful Information
Problem
Static is heard, sound cuts in and
out. Interference from other
electrical units.
Noise is heard during a call.
The handset/base unit stops
working while being used.
Pressing B does not display/dial
the last number dialled.
Mute does not turn off after the line
is connected.
The handset beeps intermittently
and/or 3 flashes.
I fully charged the batteries, but
3 still flashes.
Caller information is not displayed. L You must subscribe to Caller ID service.
While viewing caller information,
the display returns to standby
mode.
46
Cause & solution
L Place the handset and the base unit away from
other electrical appliances.
L Move closer to the base unit.
L If your unit is connected to a telephone line with
DSL service, the DSL service may be interfering
with your telephone service. We recommend
connecting a filter to the telephone line between the
base unit and the telephone line jack. Contact your
DSL service provider for more information.
L You are using the handset or base unit in an area
with high electrical interference. Place the handset
and base unit away from interference sources, such
as antennas and mobile phones.
L Disconnect the AC adaptor and turn off the
handset. Connect the AC adaptor, turn on the
handset and try again.
L The redialled number was more than 24 digits long.
Redial the number manually.
L Press {C/T}.
L Fully charge the batteries (page 9).
L Clean the charge contacts and charge again (page
9).
L It is time to replace the batteries (page 9).
L Consult your service provider/telephone company.
L If your unit is connected to a telephone line with
DSL service, the DSL service may be interfering
with your telephone service. We recommend
connecting a filter to the telephone line between the
base unit and the telephone line jack. Contact your
DSL service provider for more information.
L Do not pause for over 1 minute while searching.