Hold the PS SIMM with the connector edge pointing toward the connector
2
(CN9 or CN10) and position the notch as shown.
Insert the PS SIMM all the way into the connector at a 30o angle, and rotate
it to the left until it snaps into place.
Make sure both metal clips on the connector are fastened, and the two pins
3
on each of the connector are pushed through the holes on the PS SIMM.
Continue with
4
Install a Windows PostScript printer driver as described by Chapter 3.
5
See
page 55
4.0.
Notch
"To close the printer cover:" on page
for Windows 95/Windows 98 or see
Metal clip
140.
page 61
for Windows NT
150
Options