Demonstration Mode; Switching The System On; Plug And Play; Switching The System To Standby Mode - Philips MC-57 User Manual

Notes:
– When the power is turned on, the disc tray may
open and close to initialise the system.
– If you do not complete Plug and Play installation,
Plug and Play will be reinitiated the next time you
turn on the power.
– If no stereo frequency is detected during
Plug and Play, "CHECK ANTENNA" will be
displayed.
– During Plug and Play, if no button is pressed
within 15 seconds, the system will exit Plug and
Play mode automatically.

Demonstration mode

The system has a demonstration mode that
shows the various features offered by the system.
To activate the demonstration
In Standby mode, press and hold DEMO
STOP on the system until "DEMO ON" is
displayed.
The demonstration will begin.
To deactivate the demonstration
Press and hold DEMO STOP on the system
until "DEMO OFF" is displayed.
The system will switch to Standby mode.
Note:
– Even if you remove the AC power cord and
reconnect it to the wall socket, the demonstration
will remain off until you activate it again.
Basic Functions

Switching the system on

In Standby/Demonstration mode
Press STANDBY ON.
The system will switch to the last selected
source.
Press CD 1•2•3 (CD 123), TUNER, TAPE,
AUX/CDR.
The system will switch to the selected source.
Press any one of the disc CD OPEN•CLOSE
(CD10 / CD20 / CD 30) button.
The system will switch to CD mode.
In Eco Power Standby mode
Press ECO POWER.
The system will switch to last selected source.
Press CD 123, TUNER, TAPE or AUX/CDR
on the remote control.
The system will switch to the selected source.
Switching the system to Standby
mode
In Demonstration mode
Press and hold DEMO STOP on the system.
In any other source mode (except Eco
Power Standby mode)
Press STANDBY ON (or B on the remote
control).
The clock will appear on the display when the
system is in Standby mode.
Switching the system to Eco
Power Standby mode (< 1 Watt)
Press ECO POWER (or press and hold B on
the remote control).
"ECO PWR" will be displayed, then the
display screen will go blank.
The low power ECO POWER LED will be
lighted.
Note:
– If you have not deactivated the demonstration, it
will resume five seconds after the system switches
to Eco Power Standby or Standby mode.
13