Makita HM1202 Instruction Manual page 7

Use a screwdriver to remove the brush holder caps.
Take out the worn carbon brushes, insert the new ones
and secure the brush holder caps.
1
002954
Lubrication
002967
This tool requires no hourly or daily lubrication because
it has a grease-packed lubrication system. It should be
relubricated after every 6 months of operation. Send the
complete tool to Makita Authorized or Factory Service
Center for this lubrication
circumstances require that you should lubricate it by
yourself, proceed as follows.
Run the tool for several minutes to warm it up. Switch off
and unplug the tool.
Loosen the six screws and remove the handle.
1
002968
Remove the crank cap using a socket wrench. Rest the
tool on the table with the bit end pointing upwards. This
will allow the old grease to collect inside the crank
housing.
Wipe out the old grease inside and replace with a fresh
grease (30 g; 1 oz). Use only Makita genuine hammer
grease (optional accessory). Filling with more than the
specified amount of grease (approx. 30 g; 1 oz) can
1. Screwdriver
2. Brush holder
2
cap
1. Screws
1
service. However,
1. Socket wrench
2. Crank cap
2
cause faulty hammering action or tool failure. Fill only
with the specified amount of grease.
002969
Reinstall the crank cap and tighten with the socket
wrench.
CAUTION:
Do not tighten the crank cap excessively. It is made
•
of resin and is subject to breakage.
Be careful not to damage the terminals or lead
•
wires especially when wiping out the old grease or
installing the handle.
To maintain product SAFETY and RELIABILITY, repairs,
any other maintenance or adjustment should be
performed by Makita Authorized Service Centers,
always using Makita replacement parts.
ACCESSORIES
CAUTION:
These accessories
•
if
recommended for use with your Makita tool
specified in this manual. The use of any other
accessories or attachments might present a risk of
injury to
attachment for its stated purpose.
If you need any assistance for more details regarding
these accessories, ask your local Makita Service Center.
Bull point(SDS-max)
•
Cold chisel(SDS-max)
•
Scaling chisel(SDS-max)
•
Clay spade(SDS-max)
•
Bit grease
•
Safety goggles
•
Hammer grease
•
Plastic carrying case
•
7
1. Hammer grease
1
or attachments
persons. Only use
are
accessory or