Download Print this page
   

Advertisement

INSTRUCTION MANUAL
Demolition Hammer
HM1202
HM1202C
002877
DOUBLE INSULATION
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
1

Advertisement

   Summary of Contents for Makita HM1202

  • Page 1

    INSTRUCTION MANUAL Demolition Hammer HM1202 HM1202C 002877 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.

  • Page 2: Specifications

    8JD, ENGLAND can only be operated on single-phase AC supply. They Responsible manufacturer: are double-insulated in accordance with European Makita Corporation Anjo Aichi Japan Standard and can, therefore, also be used from sockets GEA001-3 without earth wire. GENERAL SAFETY RULES...

  • Page 3

    Keep work area clean and well lit. Cluttered and of the power tool in unexpected situations. dark areas invite accidents. 14. Dress properly. Do not wear loose clothing or Do not operate power tools in explosive jewellery. Keep your hair, clothing, and gloves atmospheres, such as in the presence of away from moving parts.

  • Page 4: Specific Safety Rules

    25. Keep handles dry, clean and free from oil and SAVE THESE INSTRUCTIONS. grease. GEB004-2 SPECIFIC SAFETY RULES WARNING: DO NOT let comfort or familiarity with product MISUSE or failure to follow the safety rules stated in (gained from repeated use) replace strict adherence this instruction manual may cause serious personal to hammer safety rules.

  • Page 5

    Side handle (auxiliary handle) Number on adjusting dial Blows per minute 1,900 1. Side handle 1,800 2. Clamp nut 1,600 1,300 1,050 002898 CAUTION: 002903 The speed adjusting dial can be turned only as far • as 6 and back to 1. Do not force it past 6 or 1, or The side handle can be swung 360°...

  • Page 6: Replacing Carbon Brushes

    OPERATION 1. Bit 2. Tool holder Chipping/Scaling/Demolition cover 002922 If the bit cannot be pushed in, remove the bit. Pull the 002945 tool holder cover down a couple of times. Then insert the bit again. Turn the bit and push it in until it engages. Hold the tool firmly with both hands.

  • Page 7

    Wipe out the old grease inside and replace with a fresh grease (30 g; 1 oz). Use only Makita genuine hammer grease (optional accessory). Filling with more than the specified amount of grease (approx. 30 g; 1 oz) can...

  • Page 8

    Makita Corporation Anjo, Aichi, Japan 884248-226...

This manual also for:

Hm1202c

Comments to this Manuals

Symbols: 0
Latest comments: