Troubleshooting - Panasonic UF-6300 Operating Instructions Manual

Troubleshooting

Troubleshooting
If You Have Any of These Problems
Mode
During Transmission Document doesn't
feed/multiple feed
Document jam
Does not stamp
Stamp too light
Transmission Copy Vertical lines on the
Quality transmitted document
Transmitted document
is blank
During Reception No recording paper
Recording paper jam
Recording paper
doesn't advance into
machine
Recording paper
doesn't eject after
printing
Recording papers are
not stacked in
sequence. Machine
does not print from the
last page received.
Document auto
reduction doesn't work
Out of toner
Symptom
1. Check that your document is free of staples and paper
clips, and that it is not greasy or torn.
2. Check that your document is the right type to send through
a fax machine by consulting the list on "Documents You
Cannot Send". If your document has the characteristics
listed, make a photocopy of your document and send the
copy instead.
3. Check that the document is loaded properly.
4. Adjust the ADF Pressure.
The information code 030 or 031 will appear on the display if
the document becomes jammed.
1. Check if Stamp LED is lit.
2. Check Fax parameter No. 04 and No. 28 settings.
Replace stamp.
Check own copy quality. If copy is OK, your machine has no
problem, so report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning Area.
1. Make sure the document is set face down.
2. Check own copy quality. If copy is OK, your machine has
no problem, so report to the receiving party that they have a
problem. If copy is NG, clean the Document Scanning
Area.
The information code 010 will appear on the display if the
paper runs out.
The information code 001, 002, 007 or 008 will appear on the
display if the paper gets jammed.
Make sure that there is paper in the Paper Cassette. Follow
the instructions for loading paper.
Check to see if the recording paper is jammed inside of the
machine.
Check if Fax Parameter No. 65 is set to valid.
Check Print Reduction settings.
The information code 041 will appear on the display if the
Toner Cartridge runs out of toner.
Cause / Action
Continued on the next page...
page
42
43
148
145
45
36
37
149
146
146
20
144
20
144
39
72
18
137