Viewing Computer Images - Mitsubishi Electric HC910 User Manual

Viewing computer images

Viewing computer images
A. Connecting the projector to a computer
Preparation:
• Make sure that the power of the projector and that of the computer are turned off.
• When connecting the projector to a desktop computer, disconnect the RGB cables that are connected to the
monitor.
COMPUTER IN/
COMPONENT VIDEO IN
1
COMPONENT VIDEO IN
S-VIDEO IN
VIDEO IN
DVI-D (HDCP) IN
1
COMPONENT VIDEO IN
S-VIDEO IN
VIDEO IN
• Turn on the power of the projector before that of the computer.
• Additional devices, such as a conversion connector and an analog RGB output adapter, are required depending
on the type of the computer to be connected.
• Use of a long cable may decrease the quality of projected images.
• Also read the instruction manual of the equipment to be connected.
• Images may not be projected correctly, depending on the type of the connected computer.
• Contact your dealer for details of connection.
B. Plugging the power cord
Plug the power cord in the same way as described in "Viewing video images." (See Page 14.)
EN-18
2
to monitor port to monitor port
RGB cable RGB cable
2
to DVI
DVI cable
For analog connection:
1. Connect one end of the supplied RGB cable to the
COMPUTER IN/COMPONENT VIDEO IN terminal of the
projector.
2. Connect the other end of the RGB cable to the monitor
port of the computer.
• Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the
type of the computer to be connected.
• When viewing images supplied from an analog-connected
computer, press the COMPUTER button on the remote
control.
• This projector does not support 3-line signals (SYNC-ON-
GREEN signals).
For digital connection:
1. Connect one end of a commercially available DVI cable to
the DVI-D IN terminal of the projector.
2. Connect the other end of the DVI cable to the DVI terminal
of the computer.
• Additional devices, such as a conversion connector and an
analog RGB output adapter, are required depending on the
type of the computer to be connected.
• When viewing images supplied from a digital-connected
computer, press the DVI-D(HDCP) button on the remote
control.