Signal Condition
Checks the signal condition.
Watching
Not valid in Analogue mode
●
Antenna System
(One LNB
/
MiniDiSEqC
Sets the antenna system to use plural LNBs for receiving several satellites.
Watching
This TV supports DiSEqC Version 1.0.
●
For DVB-S mode
●
LNB Configuration
Selects the satellite for each LNB.
Watching
For DVB-S mode
●
Attenuator
(On
/ Off)
Automatically reduces the DVB-C signal to avoid the interference.
If the DVB-C signal is too strong, the interference may occur. In this case,
●
set to
On
to weaken the signal automatically.
Add TV Signal
Adds the TV mode.
This function is available if you skip any modes to tune in
●
first using the TV.
= Note =
The settings in
Tuning Menu
●
The menu name varies depending on the TV mode.
/
DVB-C Tuning Menu
Tuning and editing channels
/
DiSEqC 1.0
/
Single
Tuning and editing channels
Tuning and editing channels
are applicable only for the selected TV mode.
/
DVB-T Tuning Menu
- 223 -
Signal Condition
Cable)
Auto Setup
Auto Setup
Auto Setup
(DVB-S Tuning Menu
/
Analogue Tuning
for
Menu)