Makita 4334D Instruction Manual page 8

(3)
(2)
(4)
2
4
1. Blade holder
2. Clamp
3. Slot
4. Roller
5. Blade
1
(5)
2
1. Blade installing lever
2. Blade
1
(6)
1. Blade installing lever
8
2. Pull the blade installing lever in the (2) direction until it stops with a little
002720
click. If you have difficulty pulling it out, try to do so while moving it back
and forth in the (3) direction.
3. Rotate the blade installing lever in the (4) direction until the clamp pro-
trudes 5 - 7 mm from the blade holder.
CAUTION:
• If you rotate the blade installing lever excessively, the clamp will also
rotate and finally come off. In this case, re-install it properly as later
described in "Installing clamp''.
4. With the blade teeth facing forward, insert the blade into the blade holder
002721
as far as it will go. Make sure that the back edge of the blade fits properly
into the groove of the roller.
1
3
5
5. With the blade held against the blade holder, rotate the blade installing
002722
lever in the (5) direction until it stops.
6. With the blade installing lever held in this position, push it in the (6) direc-
002723
tion. Then rotate the blade installing lever to its original position.