Makita 4334D Instruction Manual page 15

1
(7)
1. Blade installing lever
1. Limit mark
2
1. Brush holder cap
2. Screwdriver
ACCESSORIES
CAUTION:
• These accessories or attachments are recommended for use with your Makita tool specified in this manual. The
use of any other accessories or attachments might present a risk of injury to persons. Only use accessory or
attachment for its stated purpose.
If you need any assistance for more details regarding these accessories, ask your local Makita service center.
• Jig saw blades
• Various type of Makita genuine batteries and
chargers
• Hex wrench 3
• Rip fence (guide rule)
• Circular guide
3. Grasp the clamp with your fingers so that it will not turn, then rotate the
002784
blade installing lever in the (7) direction until it stops. The clamp will go in
the blade holder.
Replacing carbon brushes
001145
Remove and check the carbon brushes regularly. Replace when they wear
down to the limit mark. Keep the carbon brushes clean and free to slip in the
holders. Both carbon brushes should be replaced at the same time. Use only
identical carbon brushes.
1
Use a screwdriver to remove the brush holder caps. Take out the worn carbon
002786
brushes, insert the new ones and secure the brush holder caps.
To maintain product SAFETY and RELIABILITY, repairs, any other mainte-
nance or adjustment should be performed by Makita Authorized Service Cent-
ers, always using Makita replacement parts.
1
• Plastic base plate
• Anti-splintering device
• Plastic cover
• Vacuum head
• Hose (For vacuum cleaner)
15