[Min. Shtr Speed]; [I.resolution] - Panasonic Lumix DMC-FT3 Operating Instructions Manual

For details on [Rec] Mode menu settings, refer to P44.
You can take bright pictures in dark places by setting [Min. Shtr Speed] slower. Also, you
can set it faster to reduce the blur of the subject.
Applicable modes:
[AUTO], [1/125], [1/60], [1/30], [1/15], [1/8], [1/4], [1/2], [1]
Minimum shutter speed setting
Brightness
Jitter
Note
•
This should usually be set to [AUTO] to take pictures. (When you select a minimum shutter
speed other than [AUTO], [
•
When [AUTO] is selected, shutter speed may be set up to 1 second when there is not much
jitter to adjust with the [Stabilizer], or when [Stabilizer] is set to [OFF].
•
Setting [Min. Shtr Speed] to slower speed might increase the chance of jitter, so we
recommend using a tripod and the self-timer for taking pictures.
•
Setting [Min. Shtr Speed] to faster speed might make the picture darker, so we recommend
recording the picture in well-lit area. If correct exposure cannot be achieved, [
red when the shutter button is pressed halfway.
For details on [Rec] Mode menu settings, refer to P44.
Pictures with sharp profile and resolution can be taken by utilising the Intelligent
Resolution Technology.
Applicable modes:
[ON] [i.Resolution] is activated.
[i.ZOOM] [i.Resolution] is activated, and the zoom magnification is increased by
approximately 1.3
[OFF]
Note
•
Refer to P55 for information about the Intelligent Zoom.

[Min. Shtr Speed]

·
] appears on the screen.)

[i.Resolution]

·
without noticeable deterioration in the picture.
k
Recording
1/125
Darker
Less
—
- 106 -
1
Brighter
More
] will flash in