The picture cannot be recorded.
•
Is the mode set to Recording Mode?
•
Is there any memory remaining on the built-in memory or the card?
> Delete the pictures which are not necessary to increase the available memory.
•
You may not be able to record for a short while after turning the power on when using a large
capacity card.
The recorded picture is whitish.
•
The picture can become whitish if there is dirt e.g. fingerprints on the lens.
> When it is dirty, lightly wipe the surface of the lens with soft and dry cloth.
•
Is the inside of the lens fogged?
> There is condensation. Refer to
P6
for what to do.
The recorded picture is too bright or dark.
> Check that the exposure is correctly compensated.
•
Setting the [Min. Shtr Speed] to faster speed might make the picture darker.
> Set the [Min. Shtr Speed]
Multiple pictures are taken at one time.
> Set Auto Bracket
•
Has [Hi-Speed Burst]
The subject is not focused properly.
•
The focus range varies depending on the recording mode.
> Set to the proper mode for the distance to the subject.
•
The subject is beyond the focus range of the camera.
•
There is camera shake (jitter) or the subject is moving slightly.
The auto-focus and other operations are not working normally.
•
Turn the power on again. If the operations are still not working normally, remove the power and
consult the dealer or your nearest Service Centre.
Recording
(P29)
"
When inner side of the lens is fogged (condensation)
(P106)
to slower speed.
(P64)
or [Burst]
(P107)
(P74)
or [Flash Burst]
Others
(P63)
of the [Rec] Mode menu to [OFF].
(P75)
in Scene Mode been set?
(P32)
- 176 -
(P42)
(P31)
"
on