Makita 3601B Instruction Manual page 8

1
2
3
4
5
6
1. Bit
2. Base
3. Templet
4. Workpiece
5. Distance (X)
6. Outside diameter of the templet
guide
7. Templet guide
1
2
3
4
1. Wing bolt (B)
2. Fine adjusting screw
3. Wing bolt (A)
4. Trimmer guide
5. Wing bolt (C)
6. Guide roller
8
Secure the templet to the workpiece. Place the tool on the templet and move
003695
the tool with the templet guide sliding along the side of the templet.
7
NOTE:
• The workpiece will be cut a slightly different size from the templet. Allow
for the distance (X) between the bit and the outside of the templet guide.
The distance (X) can be calculated by using the following equation:
Distance (X) = (outside diameter of the templet guide - bit diameter) / 2
Trimmer guide (Accessory)
005047
Trimming, curved cuts in veneers for furniture and the like can be done easily
with the trimmer guide. The guide roller rides the curve and assures a fine cut.
Install the trimmer guide on the tool base with the wing bolts (B). Loosen the
005048
wing bolt (A) and adjust the distance between the bit and the trimmer guide by
turning the fine adjusting screw (1.5 mm per turn). At the desired distance,
tighten the wing bolt (A) to secure the trimmer guide in place. When adjusting
the guide roller up or down, loosen the wing bolt (C). After adjusting it, tighten
the wing bolt (C) securely.
6
5