Makita 3707 Instruction Manual page 9

1
6
7
1. Wing nut
2. Wave washer
3. Flat washer
4. Guide plate
5. Straight guide
6. Centre hole
7. Bolt
1
6
7
1. Wing nut
2. Wave washer
3. Flat washer
4. Guide plate
5. Straight guide
6. Centre hole
7. Bolt
1. Nail
2. Center hole
3. Straight guide
Circular work
001993
Circular work may be accomplished if you assemble the straight guide and
2
guide plate as shown in the figures.
3
Min. and max. radius of circles to be cut (distance between the center of circle
and the center of bit) are as follows:
Min.: 70 mm
4
Max.: 221 mm
5
For cutting circles between 70 mm and 121 mm in radius.
For cutting circles between 121 mm and 221 mm in radius.
001994
2
NOTE:
3
• Circles between 172 mm and 186 mm in radius cannot be cut using this
guide.
4
5
Align the center hole in the straight guide with the center of the circle to be cut.
001712
Drive a nail less than 6 mm in diameter into the center hole to secure the
straight guide. Pivot the tool around the nail in clockwise direction.
1
2
3
9