Functional Description - Makita 3707 Instruction Manual

FUNCTIONAL
DESCRIPTION
1
2
3
1. Base
2. Lever
3. Scale
4. Adjusting roller
1
1. Switch lever
CAUTION:
• Always be sure that the tool is switched off and unplugged before
adjusting or checking function on the tool.
Adjusting bit protrusion
001698
To adjust the bit protrusion, loosen the lever and move the tool base up or
down as desired by turning the adjusting roller. After adjusting, tighten the
lever firmly to secure the tool base.
4
Switch action
001982
CAUTION:
• Before plugging in the tool, always be sure that the tool is switched off.
To start the tool, move the switch lever to the I (ON) position. To stop the tool,
move the switch lever to the O (OFF) position.
Electronic function
For model 3707FC only
The tool equipped with electronic function are easy to operate because of the
following features.
Constant speed control
Electronic speed control for obtaining constant speed. Possible to get fine fin-
ish, because the rotating speed is kept constant even under load condition.
Soft start
Soft-start feature minimizes start-up shock, and makes the tool start smoothly.
Lighting up the lamps
For model 3707F/3707FC only
CAUTION:
• Do not look in the light or see the source of light directly.
To turn on the lamp, start the tool. Then, the lamp lights up the top of the bit.
To turn it off, stop the tool.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp. Be careful not to
scratch the lens of lamp, or it may lower the illumination.
5