Makita BTD040 Instruction Manual page 8

ASSEMBLY
12 mm
(15/32")
1 2
1. Bit
2. Sleeve
8
CAUTION:
• Always be sure that the tool is switched off and the
battery cartridge is removed before carrying out any
work on the tool.
Installing or removing driver bit or socket bit
001266
Use only the driver bit or socket bit shown in the figure. Do
9 mm
not use any other driver bit or socket bit.
(3/8")
To install the bit, pull the sleeve in the direction of the arrow
001267
and insert the bit into the sleeve as far as it will go. Then
release the sleeve to secure the bit.
To remove the bit, pull the sleeve in the direction of the arrow
and pull the bit out firmly.
NOTE:
• If the bit is not inserted deep enough into the sleeve, the
sleeve will not return to its original position and the bit
will not be secured. In this case, try re-inserting the bit
according to the instructions above.