Troubleshooting; Messages On The Unit's Display - Panasonic Diga DMR-XS380 Operating Instructions Manual

Messages on the unit's display

Troubl
eshooti
ng
The following messages or service numbers appear
on the unit's display when something unusual is
detected during startup and use.
DVD
("∑" stands for a number.)
The remote control and main unit are using
different codes. Change the code on the remote
control.
GUIDE
TV Guide data is being downloaded. (
FINISH
The software (firmware) update is complete.
( 87)
HARD ERR
If there is no change after turning the unit on and
off, consult the dealer where the unit was
purchased.
NoERAS
You cannot delete items on this disc.
The disc may be damaged. Use a new disc.
NoREAD
The disc is dirty or badly scratched. The unit
cannot record, play, or edit. (
This message may appear when the lens cleaner
has finished cleaning.
Press [< OPEN/CLOSE] on the main unit to eject
the disc. ( 14)
NoWRIT
You cannot write to this disc.
The disc may be damaged. Use a new disc.
PLEASE WAIT
Displayed when the unit is started and turned off.
There was a power failure or the AC plug was
disconnected while the unit was on. The unit is
carrying out its recovery process. This process
restores the unit to normal operation. The unit is
not broken. Wait until the message disappears.
90
VQT2J57
1 Press and hold [OK] and the
indicated number button at
the same time for more than
5 seconds. ( 85)
2 Press and hold [OK] for more
than 5 seconds.
19)
103)
PROG FULL
There are already 32 timer programmes. Delete
unnecessary timer programmes. (
REMOVE
The USB device is drawing too much power.
Remove the USB device.
START
Update of the software (firmware) is started.
You cannot operate the unit until the update is
complete. ( 87)
SW-DL
Software (firmware) is downloading.
Download will stop when the unit is turned on, or
the timer recording starts. (
UNSUPPORT
You have inserted a disc the unit cannot play or
record on. ( 98)
You tried to operate with a non-compatible USB memory.
UPD /
("∑" stands for a number.)
The software (firmware) is being updated.
You cannot operate the unit until the update is
complete. ( 87)
U50
The terminal, antenna cable or DISH is short-
circuited as for both DISH IN 1 and DISH IN 2.
Check the connection status. (
U50 1
The terminal, antenna cable or DISH is short-
circuited as for DISH IN 1. Check the connection
status. ( 8)
U50 2
The terminal, antenna cable or DISH is short-
circuited as for DISH IN 2. Check the connection
status. ( 8)
29)
87)
8)