Panasonic Diga DMR-XS380 Operating Instructions Manual page 11

6
Press [BACK/RETURN
7
Enter the new PIN.
PIN Entry
Enter a new 4-digit PIN, then press OK.
This PIN will be used for controlling viewing and playback.
PIN will be set to "0000" by pressing "RETURN" when there is no
number input.
- -
RETURN
≥Make a note of PIN in case you forget it.
≥The default PIN is "0000".
1 Select the number, then press [1].
2 Repeat step 1.
3 Press [OK] twice.
8
Set "Power Save" to "On", "On Timer"
or "Off", then press [OK].
Power Save in Standby
From
0
Standby power consumption is reduced by disabling
Quick Start function and AV2 loop-through in standby.
Home Network ( DLNA ) function is not available in both standby
and power on modes.
OK
RETURN
On Power consumption will be reduced
to a minimum level in standby mode.
On Set period of power save and then
Timer press [OK].
≥Power Save in Standby mode is
activated at the set time period.
Off It is possible to start quickly from the
standby mode. (Quick Start mode)
≥If you use Home Network (DLNA)
Function (
function is not available with other
settings.
≥Video from AV2 input cannot be viewed with
this unit in standby mode when Power Save in
Standby mode is activated.
].
- -
-
Number 0 9
Power Save
On
To
6
66), select "Off". This
When the following screen appears, Easy setting
is complete.
Easy Setting
Easy Setting has been completed.
To use Internet functions, network connection needs
to be made first. Proceed Network Easy Settings ?
Select "Yes" to start. Select "No" to exit the Setup.
Yes
OK
≥Select "Yes" to proceed to "Network Easy Settings".
( 12)
≥Select "No" to finish the Setup.
To stop partway
Press [BACK/RETURN
When the message below appears
No satellite signals detected at dish input 2.
Please check dish installation / connection before starting search,
otherwise record / playback functions will be limited.
This screen appears when this unit does not detect
the connection to DISH IN 2.
When you connect DISH IN 1 only press [OK], then
go to the next step.
When you connect both DISH IN 1 and 2, turn this
unit off and check your connection. Then perform
from step 1.
To display the Owner ID information on TV
Press and hold [∫] on the main unit for more than
5 seconds.
The PIN is not displayed.
To edit the Channel List (
List)
To check the signal condition (
Condition)
To change the Owner ID information (
Owner ID)
To change PIN ( 86, PIN Entry)
No
].
75, freesat Channel
77, Signal
86,
VQT2J57
11