Advertisement
Power Beam Installation (Optional)
Position Power Beam where desired on top or underside of worksurface. Note
on Static Dissipative worksurfaces install insulating washers
provided between power beam and worksurface. Use power
beam as template and drill 5/16" diameter x
5/16" deep holes for insulators. ***Read
Warning Box Page 4. Fasten to bench with
the #10 x 1" wood screws provided.
Riser Shelf—Box Style (Optional)
Invert instrument shelf onto soft, clean surface
to avoid damage to laminate. Place box
supports flush with end and rear of riser shelf.
Fasten with the #10 x 1" wood screws provided.
Invert shelf and boxes. Place flush with end
and rear of worksurface. Screw to worksurface
with the #10 x 1" wood screws provided. Note:
On static dissipative worksurfaces place
insulator between riser box and
worksurface. Using box as a template, drill
5/16 diameter X 5/16" deep holes for
insulator. Install box support cover or optional
electrical panels. ***Read Warning Box on
Page 4.
Riser Shelf—Column Style (Optional)
This system requires drilling four 3/8" diameter holes, on
36", 48" or 60" centers, depending on the module size
required. The "J" bolts provided hook over the embosses in
the center of the columns. Place the mounting plate under
the column and mount to worksurface using the 5/16"-18
lock nuts, 5/16" flat washers provided. Align rear of shelf
with rear of top mounting plate. Fasten riser shelf through
holes in the plate using wood screws provided. Note: On
Static Dissipative worksurfaces place insulator
between mounting plate and worksurface. ***Read
Warning Box on Page 4
Note: Prior to drilling bench tops ensure that there will
not be interference with any undersurface components.
Advertisement
