Advertisement
VSI-8 Vertical Space Integrator (Optional)
Position the mounting plates of the columns on the worksurface approximately 3/4" from the
rear of the surface. Using the modesty panel as a guide, centre the columns horizontally on
36", 48", 60", or 72" centers as required. Using the mounting plates as templates, mark and
drill eight 5/16" diameter holes. Using the 1/4"-20 bolts, washers and lock nuts provided install
the columns as shown. Do not tighten the hardware until the modesty panel is installed. Note:
On Static Dissipative worksurfaces place insulator between mounting plate and
worksurface. ***Read Warning Box Below.
Note: Prior to drilling bench tops ensure that there will not be interference with any
undersurface components.
Failure to comply with the proper installation of
insulating grommets or gaskets may result in
hazardous electrical conditions for personnel.
The ultimate responsibility for personnel safety
lies with the end user.
***Warning!
Advertisement
