Advertisement
Back & End Stops (Optional)
Back and end stops are pre-punched
for easy installation. After worksurface
has been mounted on frame, fasten
stops to back and sides of worksurface
with the #10 x 1" wood screws
provided.
Rear & end Modesty Panels (Optional)
Fasten all 3 panels to leg frame using the #8 x
3/4" self-drilling screws provided.
Footrest (Optional)
Fasten footrest into crossbeam of leg
assembly using the #10-32 Phillips
machine screws provided.
Hangers for 30" deep workbench are shown.
Hangers for 36" deep workbench are
approximately 6" longer, while the drawer
mounts in the same position.
Drawer Installation (Optional)
For ease of assembly the drawers can be removed by releasing the
disconnects on both sides of the slides and pulling the drawer forward
to separate the slides. Using 1/4"-20 x 1" machine screws loosely
fasten "L" shaped hangers to the rear of the drawer. Swing the front of
the hangers away to form a "V". Lift drawer into position. Set drawer
hangers on rear load beam flange. Swing the front of the hangers
back in, and rest them on the front load beam. Fasten the drawer to
the front of the hangers, slide into position along the length of the
Advertisement
