Advertisement
Quick Links
Arlink 7000 Workstation
Instructions for Assembly
Basic Bench Assembly
Undersurface Accessories
Above Surface Accessories
VSI Mounting Instructions
Making Workspace Work® is a trademark of Lista International Corporation.
Creation Date
Document Number
Rev
Description
Feb/01/06
AS70007
B
Arlink 7000 Workstation
This manual is proprietary information of Lista International Corporation. Unauthorized
reproduction of any portion of the manual is prohibited without consent of Lista
International Corporation. The material in this manual is for informational purposes
only. It is subject to change without notice. Lista International Corporation assumes
no responsibility for any typographical errors contained in the manual.
© 2006 by Lista International Corporation, all rights reserved.
106 Lowland Street
Holliston, MA 01746-2094
E-mail: sales@ listaintl.com
All rights reserved.
For questions or technical support, call 1-800-722-3020
ISO 9001 Certified
Advertisement
Related Manuals for LISTAESCAN ARLINK 7000
Summary of Contents for LISTAESCAN ARLINK 7000
- Page 1 Arlink 7000 Workstation Instructions for Assembly Basic Bench Assembly Undersurface Accessories Above Surface Accessories VSI Mounting Instructions Making Workspace Work® is a trademark of Lista International Corporation. Creation Date Document Number Description Feb/01/06 AS70007 Arlink 7000 Workstation This manual is proprietary information of Lista International Corporation. Unauthorized reproduction of any portion of the manual is prohibited without consent of Lista International Corporation.
-
Page 2: Table Of Contents
Table of Contents Basic Bench Assembly Step 1 .....3 Basic Bench Assembly Step 2....3 Basic Bench Assembly Step 3....3 Basic Bench Assembly Step 4....3 Back & End Stops .........4 Rear & End Modesty Panels ....4 Footrest..........4 Drawer Installation........4 Powerbeam Installation......5 Riser Shelf—Box Style ......5 Riser Shelf—Column Style....5 VSI-8 Vertical Space Integrator ....5... -
Page 3: Basic Bench Assembly Step 1
Arlink 7000 Assembly Instructions Step 2 Assemble frame by attaching load beams and stiffener to legs using the 1/4”-20 x 3/4” hex bolts 1/4” flat washers and 1/4” lock washers included. Leave bolts loose until all are in place, then square up the frame and tighten bolts. -
Page 4: Back & End Stops
Back & End Stops (Optional) Back and end stops are pre-punched for easy installation. After worksurface has been mounted on frame, fasten stops to back and sides of worksurface with the #10 x 1” wood screws provided. Rear & end Modesty Panels (Optional) Fasten all 3 panels to leg frame using the #8 x 3/4”... -
Page 5: Powerbeam Installation
Power Beam Installation (Optional) Position Power Beam where desired on top or underside of worksurface. Note on Static Dissipative worksurfaces install insulating washers provided between power beam and worksurface. Use power beam as template and drill 5/16” diameter x 5/16” deep holes for insulators. ***Read Warning Box Page 4. -
Page 6: Vsi-8 Vertical Space Integrator
VSI-8 Vertical Space Integrator (Optional) Position the mounting plates of the columns on the worksurface approximately 3/4” from the rear of the surface. Using the modesty panel as a guide, centre the columns horizontally on 36”, 48”, 60”, or 72” centers as required. Using the mounting plates as templates, mark and drill eight 5/16”... - Page 7 Document Number: AS70007 Print Date: May, 2006 This manual is proprietary information of Lista International Corporation. Unauthorized repro- duction of any portion of this manual is prohibited without written consent of Lista International Corporation. The material in this manual is for informational purposes only. It is subject to change without notice.