Panasonic WJ-SX150 Operating Instructions Manual page 37

To Control a Recorder via the Network
The following is the description of the connection between
a recorder and this unit to control the recorder via the net-
work.
1. Set the recorder's unit address to a number larger than
5. (Refer to the recorder's operating instructions.)
2. Connect the unit's CAM OUT 1 to 16 connectors to the
recorder's VIDEO IN 1 to 16 connectors with a coaxial
cable.
3. Connect the unit's DATA HDR and DATA4 connectors
to the recorder's DATA port with a daisy chain connec-
tion cable kit (WV-CA48/10K).
(The control data and alarm signal will be output from
the unit to the recorder.)
4. Select the recorder's new unit address, which is set in
step 1, for DATA HDR in the Data Port window. (Refer to
p. 65.)
5. Through a browser, set the unit address of an optional
network board (WJ-HDB502) to a number other than 1.
(Refer to WJ-HDB502 Operating Instructions.)
6. Refer to p. 37 and 38 for MONITOR OUT connection,
MULTI SCREEN OUT connection, and EXT IN connec-
tion.
39
WJ-SX150 Matrix Switcher
ALARM
DATA HDR DATA 4 DATA 3 DATA 2
TERM
OFF ON
PS•DATA RS485(CAMERA)
16 15 14 13 12 11 10 9
IN
OUT
16 15 14 13 12 11 10 9
CAMERA
DATA HDR DATA4
(PS·Data)
Daisy Chain Connection Kit
(WV-CA48/10K)
MULTI SCREEN
OUT
DATA
IN EXT STORAGE COPY
SPOT
OUT
OUT
CONTROL ALARM
MULTI SCREEN OUT AUDIO
16 15 14 13 12 11 10 9
IN
OUT
16 15 14 13 12 11 10 9
VIDEO
Digital Disk Recorder*
HUB/Router
* WJ-HD500A or Newer Models with Network Board (WJ-HDB502)
** LAN : Local Area Network
Notes:
• You will need WJ-HD500A or a newer model, in which
an optional network board (WJ-HDB502) is installed.
• Select the PS·Data protocol for the DATA 4 setting.
(Refer to p. 49 DATA 4/PSD PORT SELECT or p. 65
Data Port.) If the terminal mode is selected, you cannot
control the recorder.
• If its unit address is set to 1, the recorder will not be
operable.
• If the recorder's unit address in step 1 and the DATA
HDR setting in step 4 are different, the recorder will not
be operable.
• In these connections, you cannot use a PS·Data system
controller.
Monitor
MONITOR
EXT IN
OUT
EXT IN 3 1
(PLAY IN)
SERIAL
CAMERA
RS485(CAMERA)
SW IN
DATA 1
LINE
SELECT
2 4
4 2
EXT OUT
MONITOR OUT
(REC OUT)
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
GEN-LOCK OUT
SIGNAL GND
REMOTE(WV-CU50)
DATA
10/100 10/100 BASE-T
BASE-T
SERIAL
MODE
8 7 6 5 4 3 2 1
8 7 6 5 4 3 2 1
LAN cable
LAN**
39