Use; Sensor Switches; Switching On - Miele KM 530 Operating And Installation Instructions

Use

Sensor switches

This hob is equipped with electronic
sensor switches which react to finger
contact.
To operate a cooking zone touch the
relevant sensor switch. Each time you
touch a sensor switch an audible tone
sounds.
Make sure that you only touch the
sensor you require (except when
switching off a cooking zone), and
that you touch the centre of the
sensor.
Take care to keep the control area
clean. Do not place anything on the
control area. The sensors may fail to
react or they could mistake the
article or any dirt for a fingertip
contact, thereby activating a
function or even causing the hob to
switch off automatically (see Safety
switch-off.)
Never place hot pans on the
sensors. The electronic unit
underneath could get damaged.
24

Switching on

The hob must be switched on before
any of the zones can be used.
To switch the hob on:
^ Touch the ON/OFF sensor s.
A 0 appears in the display for each of
the zones. If no further entry is made,
the hob will switch itself off after a few
seconds for safety reasons.
To switch a cooking zone on:
^ Select a power setting between 1 and
9 by touching the - or + sensor.
To select cooking with Auto heat-up,
press the - sensor first, see "Auto
heat-up". To select cooking without
Auto heat-up press the + sensor first.
If you wish to switch on another
cooking zone, and the 0 for that zone
has already gone out, simply press the
- or + briefly. The 0 will appear and you
can select a power setting (with or
without Auto heat-up).