Table of Contents
Advertisement
Safety instructions for
installation
Fit the wall units and extractor hood
before fitting the hob to avoid
damaging the appliance.
The veneer or laminate coatings of
worktops (or adjacent kitchen
units) must be treated with 100 °C
heat-resistant adhesive which will not
dissolve or distort.
Any backmoulds must be of
heat-resistant material.
This equipment may only be used
in mobile installations such as
ships, caravans, aircraft etc. if a risk
assessment has been carried out by a
suitably qualified engineer.
The hob may not be built in over a
fridge, fridge-freezer, freezer,
dishwasher, washing machine or
tumble dryer.
After installing the hob, ensure that
the connection cable cannot come
into contact with the underside of the
appliance. Make sure that there is no
mechanical obstruction, such as a
drawer, which could damage it.
Observe carefully the safety
distances given on the following
pages.
Do not use any sealant unless
expressly instructed to do so. The
sealing strip under the edge of the top
part of the hob provides a sufficient
seal for the worktop (see "Sealant").
All dimensions in this instruction booklet
are given in mm.
Installation
45
Hide quick links:
Advertisement
Table of Contents
