Before Operating This Set
Connecting the Main plug to the Wall Outlet
How to Turn the Power On
Battery Installation
1
Open the cover.
A p p l y s l i g h t d o w n w a r d
p r e s s u r e w h i l e p u l l i n g
towards the bottom.
Do not use rechargeable (Ni-Cd) batteries.
They are different in shape and performance and may fail to ensure correct operation.
Battery cautions
The incorrect use of batteries can cause electrolyte leakage which will corrode the Remote Control or cause the
batteries to burst.
Old Batteries
Replace both batteries at the same time.
Note:
Main plug types vary between countries. The main plug shown at left
may therefore not be the type fitted to your set.
When connecting the Main plug to the wall outlet, the power indicator
will light (Red).
Push the Power switch on the Television set to turn the set on.
The Power Indicator will light (Red).
Note:
When in the Stand-by condition (Refer to page 26), it is possible to turn
the TV set on by pushing the "Power (Stand-by)" button any of the
"Direct Position Number Selection" buttons (0 ~ 9) and Position Number
Up and Down buttons on the TV set or Remote Control.
2
B a t t e r i e s : U s e t w o " R 6 ( A A ) " s i z e
batteries.
Insert the batteries ensuring correct polarity.
This is identifiable by the "+" and " " symbols
on both the batteries and inside the battery
compartment.
Two "R6 (AA)" size
New Batteries
3
Replace the cover.
Don't mix battery types
(alkaline with carbon zinc, etc.)
Don't Recharge.
7