of the grille.
Fully tighten the small nut and bolt that passes through the rim of the grille.
FAN OPERATION：Always operate the fan in the upright position following all instructions and
recommendations listed in this manual.
FAN CONNECTION：Plug fan directly into 120V A.C., 60Hz wall outlet. Be sure plug fits
tightly in outlet. A loose connection may cause overheating and damage to the plug or fan.
NOTE: To prevent overloading a circuit, do not plug the fan into a circuit that is servicing other
TURNING FAN ON/OFF: Place fan on stable level surface. Plug fan into proper outlet. To start
the fan, press ON/SPEED button. Press ON/SPEED repeatedly to desired fan speed (1，2 or
3). Press OFF to discontinue use. Unplug fan when not in use.
TIMER FEATURE: The timer function is designed to work at any fan speed. Press timer button
and the timer indicator light illuminates (1, 2 or 4 hours). To turn the timer function off, press the
TIMER button continuously until all the timer indicator lights are off.
OSCILLATION: The fan can be set to oscillate by pushing Oscillating Knob downwards. To stop
the oscillating feature, pull up the Oscillating Knob.
REMOTE CONTROL: Place 2 AAA size batteries (not included) in the remote control. Use the
buttons on the remote in the same manner as those of the control panel. Point the remote control
towards the control panel for the sensor to receive a signal.
Do not mix old and new batteries. Do not mix alkaline, standard (carbon-zinc), or rechargeable
(nickel cadmium) batteries.
Do not dispose of batteries in fire; batteries may explode or leak.
WARNING: Changes or modifications to this unit not expressly approved by the party
responsible for compliance could void the user authority to operate to equipment.
NOTE: This equipment has been tested and found to comply with the limits for a class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
- 5 -